How to reset the surface unit

In case you forget your password, SSID, or simply changed to a frequency band your device can't access this is how you reset the surface unit:

Surface unit 1.0 

Press the "RESET" button under the rubber lid gently with a pencil or a needle once while the surface unit is fully powered.

Surface unit 2.0

Press the battery button 6 times in less than 2 seconds while the surface unit is fully powered.

If the LED pattern starts to move in a pattern back and forward the surface unit is being reset. Once the LED pattern stabilizes to the default battery status the surface unit is ready to be used.

The default SSID and password can be found on a label located on the backside of the surface unit.