First time packing instructions:
- To avoid tangle on the tether, do not pack it all at once. First enrol all the tether. Make sure that there are no knots.
2. Once you have unrolled the tether, take the loose end and put it into the tether bag and
pull it through the hole in the mesh pocket.
3. Pack the tether 1 m at a time into the tether bag.
4. Connect the end of the tether you pulled out through the mesh pocket in step 2 to
the Blueye Surface Unit and place the Blueye Surface Unit in the mesh pocket.
5. Good job!
Store the tether in the Blueye bag. The tether is manually packed in the bag after each dive. When repacking the tether, remember to pack it gradually (1 meter at a time) to avoid tangle.
Put the tools in the pocket inside the bag. The power-on magnet is already attached to the Blueye bag.
Power supply, charger, and accessories
Put the power supply and charger in the large Blueye bag and the controller in the small bag. This is to protect these devices from water and dirt.
Store the drone in the carrying box for protection and easier transportation. The box also holds the two bags for the charger and controller. Blueye bag with the tether is stored separately.